Labnet Enduro Modular 10cm x 10cm Vertical Page Electrophoresis Systems

Zoom Out Zoom In

Labnet Enduro Modular 10cm x 10cm Vertical Page Electrophoresis Systems

 

Be the first to review this product

Select a product from the dropdown and enter your quantity

OR

Additional Information

Labnet’s Enduro Vertical PAGE System is modular, allowing PAGE, electroblotting and 2D gel electrophoresis to be carried out in the same tank,simply by changing the inserts. Users can purchase only the parts they need, or a complete combined system for a cost saving over buying all three systems separately.

- Modular design– all three inserts, PAGE, electroblotting and 2D electrophoresis, have their own electrode assembly that connects into the lid of the buffer tank
- Most 10 x 10 cm.pre-cast gels, including NuSep, Bio-Rad,Invitrogen and Lonza, can be used with the Enduro PAGE system. The use of pre-cast gels saves time by eliminating the need to pour gels and wait while they polymerise
- Built for safety and endurance– the buffer tank is moulded from high quality acrylic for leakproof performance and long service life. Pins on the top of the inserts ensure that the lid is placed onto the insert in the proper orientation. These pins also aid in the removal of the lid. Removing the lid disconnects power to the electrodes
- Quick and easy set-up
    PAGE Insert:
  A set of 10 x 10 cm. plates are placed on either side of the insert and held into place by the pressure bar. An additional gel
 may be run on each side by stacking the plates. The assembly is then placed into the casting stand for pouring the gel. After the gel is polymerised, the insert is        removed from the casting stand and placed in the buffer tank
- Electroblotting Insert:
 The electroblotting insert has a capacity for 3 gels. Setting up blots is easy – gels are sandwiched in the blotting cassettes with the transfer membranes. The  cassettes are then placed in the insert, which is in turn placed in the buffer tank. Coiled electrodes in the insert generate a high intensity current, allowing transfer to  take place in about an hour
- 2D Electrophoresis Insert:
- This insert is used for running the first dimension of IEF gels. Up to 10 x 8cm. gels are poured in disposable capillary
tubes and placed in this insert. Graduated ports allow for easy insertion and removal of tubes. Blocking plugs
are included for closing off ports that are not in use
- Wide range of accessories:
– a variety of combs and spacers of varying widths are available to customise your Enduro™ system.
All are colour coded and clearly marked for easy identification. Both notched and plain plates can be purchased with spacers
permanently bound for easy set-up. Additional fibre pads and replacement cassettes are also available as well as capillary tubes,
blanking ports and tube supports. Cooling packs are also available to help reduce buffer temperature during higher voltage orlonger runs

 Ordering information:

     
E2010-PA Enduro PAGE System, includes PAGE insert, buffer tank with leads and cooling pack  
E2010-PB Enduro PAGE Electroblotting System, includes the blotting insert and PAGE system components  
E2010-P2 Enduro  PAGE 2D System, includes the 2D insert and PAGE system components  
E2010-BT Enduro  Electroblotting System, includes buffer tank, blotting insert and 3 cassettes  
E2010-BM Electroblotting Module only for use with Enduro PAGE System (E2010-P)  
E2010-2M 2D Electrophoresis Module only for use with Enduro  PAGE System (E2010-P)  
E2010-PM PAGE Module (without glass plates, combs and caster)  
E2010-PC Enduro  PAGE casting system