Hermle Z306 Benchtop, 4 x 100ml. Centrifuge

Zoom Out Zoom In

Hermle Z306 Benchtop, 4 x 100ml. Centrifuge

 

Be the first to review this product

Product is not available online. For more information on purchasing this item contact our sales office on the number below:


+44 020 8542 2283


or email scientific@zeal.co.uk

Additional Information

- Speed range: 200 – 13,500 rpm in 10 rpm increments

- Max. RCF: 17,319 x g.

- Max. volume: 4 x 100 ml.

- Running time: 59 minutes 50 seconds / 10 second increments; 99 hours 99 minutes / 1 minute increments; continuous

- Digital display of preset and actual speed / RCF and time

- Maintenance-free induction motor

- Motor driven lid lock

- Automatic rotor identification system with overspeed protection, immediately upon rotor insertion

- Active imbalance identification with safety cut-off (rotor specific)

- Imbalance tolerant drive

- Manufactured according to international safety regulations, i.e. IEC 61010

- Quick key for short runs with corresponding digital display of elapsed time in seconds

- Audible signal at the end of each run with several melody options

- Noise level under 63 dBA at max. speed

- Dimensions: 355W x 330H x 474D mm.

- Weight: 30 Kg.

- Distinct control panel (microprocessor with large LCD display):

- Simple one handed operation
- Easy to programme with gloves on
- Splash proof digital display
- Permanent indication of Preset and Actual Values
- Selection of speed in both rpm and g-force, with increments of 10
- 10 acceleration and deceleration rates, possibility of unbraked deceleration
- Direct access to parameters; no need to click through the programme
- Pre-selection of the running time from 10 sec. to 99 h 59 min or continuous
- Storage of up to 99 runs including rotor type
- Quick key for short runs
- Diagnostic programme


Ordering information:

Ordering information:  
310.00V01 Hermle Model Z306 benchtop centrifuge 
Swing-out rotors  
NOTE: All adaptors are in pack of 2 unless stated otherwise 
221.12V03 4 x 100 ml. swing-out rotor (0 – 90 degrees angle); max. speed 4500 rpm. (3350 x g.) 
626.000 Bucket 1 x 100ml., 44mm. dia., 90/108mm. length (pack of 2) 
626.001 Bucket 1 x 85ml., 38mm. dia., 90/108mm. length (pack of 2) 
626.008 Bucket 1 x 50ml., 34mm. dia., 92/118mm. length (pack of 2) 
626.009 Bucket 1 x 50ml., 29mm. dia., 90/133mm. length (pack of 2) 
626.002 Bucket 1 x 50ml. (Falcon), 29mm. dia., 116mm. length (pack of 2) 
626.010 Bucket 1 x 50ml. with rim, 29mm. dia., 116mm. length (pack of 2) 
626.011 Bucket 1 x 30ml., 25mm. dia., 95/105mm. length (pack of 2) 
626.012  Bucket 1 x 25ml., 25mm. dia., 95/110mm. length (pack of 2) 
626.003  Bucket 2 x 15ml. (Falcon), 17mm. dia., 120mm. length (pack of 2) 
626.013 Bucket 2 x 15ml. with rim, 17mm. dia., 120mm. length (pack of 2) 
626.004 Bucket 7 x 15ml., 17mm. dia., 90/108mm. length (pack of 2) 
626.005  Bucket 9 x 5-7ml., 13mm. dia., 75/100mm. length (pack of 2) 
626.014  Bucket 10 x 1.5ml., 11mm. dia., 42mm. length (pack of 2) 
626.007  Bucket 9 x 4.5ml., 12mm. dia., 75/100mm. length (pack of 2) 
626.015 Bucket 9 x 5-7ml., 13mm. dia., 65/80mm. length (pack of 2) 
626.006 Bucket 7 x 5-7ml. Vacutainer, 13mm. dia., 75/100mm. length (pack of 2) 
220.72V06 4 x 100 ml. swing-out rotor (0 – 90 degrees angle); max. speed 5000 rpm. (3885 x g.)  
605.000 Round bucket for rotor 220.72 V06 and for adaptors 705.000, etc. (pack of 2) 
605.001 Round bucket, hermetically sealed with see-through screw-cap made of PC for rotor
220.72 V06 and for adaptors 705.000, etc.(pack of 2
605.002 Screw-cap made of PC for bucket 605.000 and 605.001 (pack of 2) 
605.003 O-ring for buckets 605.000 and 605.001 (pack of 10) 
705.000 Adaptor 1 x 100ml., 40mm. dia., 90/108mm. length (pack of 2) 
705.012 Adaptor 1 x 85ml., 38mm. dia., 90/108mm. length (pack of 2) 
705.001 Adaptor 1 x 50ml., 34mm. dia., 92/118mm. length (pack of 2) 
705.010  Adaptor 1 x 50ml., 29mm. dia., 90/133mm. length (pack of 2) 
705.006 Adaptor 1 x 50ml. (Falcon), 29mm. dia., 116mm. length 
705.013 Adaptor 1 x 50ml. with rim, 29mm. dia., 116mm. length (pack of 2) 
705.014  Adaptor 1 x 30ml., 25mm. dia., 75/105mm. length (pack of 2)
705.002 Adaptor 1 x 25ml., 25mm. dia., 95/110mm. length (pack of 2) 
705.018 Adaptor 1 x 15ml.(Falcon), 17 mm. dia., 120 mm. length (pack of 2) 
705.005  Tube rack 2 x 15ml. (Falcon), 17mm. dia., 120mm. length (pack of 2).
Can only be used without bucket lid 
705.015  Tube rack 2 x 15ml. with rim, 17mm. dia., 120mm. length (pack of 2).
Can only be used without bucket lid 
705.003  Tube rack 4 x 15ml., 17mm. dia., 90/108mm. length (pack of 2) 
705.007 Tube rack 7 x 5-7ml., 13mm.dia., 75/100mm. length (pack of 2) 
705.009 Tube rack 5 x 1.5ml., 11mm. dia., 42mm. length (pack of 2) 
705.011  Tube rack 3 x 10ml. Sarstedt, 17mm. dia., 85/100mm. length (pack of 2) 
705.008 Tube rack 4 x 5-7ml., 13mm. dia., 75/100mm. length (pack of 2) 
705.016 Tube rack 4 x 10ml. Vacutainer, 17mm. dia., 75/100mm. length (pack of 2) 
605.004  Round bucket for rotor 220.72 V06 for 2 x 50ml. Falcon tubes with 29mm. dia., 116mm. length (pack of 2)
Can only be used without bucket lid 
605.005 Round bucket for rotor 220.72 V06 for 3 x 15ml. Falcon tubes with 17mm. dia., 120mm. length (pack of 2) 
Can only be used without bucket lid 
605.010  Rectangular bucket for Cyto-System (4000 rpm. / 1305 x g.)
26.5062 Carrier for cyto-container (pack of 1).
4 units required 
45.5064  Cyto-container with 2 cylindrical bore holes, 1.5ml. (pack of 1) 
45.5065 Cyto-container with 2 conical bore holes, 3ml. (pack of 1) 
23.5103 Spare cover for cyto-container (pack of 1) 
25.5085 Filter cards for cylindrical container (pack of 100) 
25.5086 Filter cards for conical container (pack of 100)
220.50V08 Swing-out rotor with 2 x 3 microtitre plate carriers, (0 – 90 degree angle), max. speed 3500 rpm (1524 x g.)  
606.001  Replacement carrier for rotor 220.50V08 (pack of 2)
706.000 Tube rack for 48 x 1.5/2.0ml. for 220.50V08 (pack of 2)
221.16V03 Swing-out rotor with 2 x 3 microtitre plates carriers, (0 – 90 degree angle), max. speed 4500 rpm (2739 x g.)  
607.000 Replacement carrier for rotor 221.16 V03 (pack of 2) 
706.000 Adaptor 48 x 1.5/2.0ml. (pack of 2) 
Fixed angle rotors:  
NOTE: All adaptors are in pack of 2 unless stated otherwise 
221.55V02 6 x 50 ml. round bottom or Falcon tubes, 30 mm. dia., angle rotor (40 degrees angle); max. speed 6,000 rpm.
(4,427 x g.) incl. inserts 603.000
708.019 Adaptor, 1 x 30ml., 25mm. dia., 92/95mm. length
708.003 Adaptor, 1 x 16ml., 18mm. dia., 100/105 mm.length
708.004 Adaptor, 1 x 15ml., 17mm. dia., 100/105mm. length 
708.030  Adaptor for 15ml. round bottom or Falcon tube, 17 mm. dia., min. / max. length: 110-116 / 125-133 (4105 / 4185 x g.)
221.19 V02 30 x 15ml. tubes, 17 mm. dia., angle rotor (35 degrees angle); max. speed 4,500 rpm. (2,830 x g.) 
701.011 Adaptor for 7ml. tubes, 13.5 mm. dia.,min. max. length: 95 / 115 mm. 
701.012  Adaptor for 5ml. tubes, 13.5 mm. dia., min. / max. length: 62 / 90 mm. 
701.015 Adaptor for 1.5ml. tubes, 11 mm. dia., length: 42 mm. 
221.54 V02  12 x 15ml. round bottom or Falcon tubes, 17 mm. dia., angle rotor (32 degrees angle); max. speed 6,000 rpm. (4,427 x g.)  
701.011  Adaptor for 7ml. tubes, 13.5 mm. dia. min. / max. length: 95 / 115 mm. 
701.012  Adaptor for 5ml. tubes, 13.5 mm. dia., min. / max. length: 62 / 90 mm. 
701.015 Adaptor for 1.5ml. tubes, 11 mm. dia., length 42 mm. 
220.87 V09 24 x 1.5/2.0ml. angle rotor (45 degrees angle); max. speed 13,500 rpm. (17,319 x g.) – with push on lid 
704.004  Adaptor set for 0.2/0.4ml., 6mm. dia., 45mm. length (pack of 6) 
704.005 Adaptor set for 0.5ml., 8mm. dia., 45mm. length (pack of 6) 
220.87 V10 24 x 1.5/2.0ml. angle rotor (45 degrees angle); hermetically sealable; max. speed 13,500 rpm. (17,319 x g.),
with hermetically sealed lid 
704.004 Adaptor set for 0.2/0.4ml., 6mm. dia., 45mm. length (pack of 6)
704.005 Adaptor set for 0.5ml., 8mm. dia., 45mm. length (pack of 6)
221.17 V03 30 x 1.5/2.0ml. angle rotor (45 degrees angle); hermetically sealable; max. speed 12,000 rpm. (15,133 x g.),
with hermetically sealed lid 
704.004 Adaptor set for 0.2/0.4ml., 6mm. dia.,  45mm. length (pack of 6)
704.005 Adaptor set for 0.5ml., 8mm. dia.,  45mm. length (pack of 6)